Rohloff internal routing

[Blacklabbikes]

I was thinking about making up a stainless port that terminated the outers of both cables at the headtube and running a pair of thin stainless tubes to an equivlent port in the chainstay - anyone had a go at this before?

Ta
Joe

[Rody]

Joe,

I’ve done a lot of internal Rohloff cable routing, creating both entrance and exit ports.

Here’s one example to peruse...

Groovy Cycleworks 33-988-537: Martins 65b day 2...

Rody

[Blacklabbikes]

Thanks Rody

My principle concern is the size of the hole in the DT so I was going to go into the top of the headtube too - albeit not with such a neat block. I'll press on.

Many thanks for the link!

[Rody]

No worries Joe, lots more buried in the blog if you care to look.

Best wishes,

Rody