Figured this belongs here:
Figured this belongs here:
Steve Garro, Coconino Cycles.
Frames & Bicycles built to measure and Custom wheels
Hecho en Flagstaff, Arizona desde 2003
www.coconinocycles.com
www.coconinocycles.blogspot.com
Thanks Steve.
Well, the race was rescheduled due to rain and changed from a race to a timed ride with a group start. I got the hole shot and no one passed me, so I'm going to say it went well, though it was very much unofficial.
sourced from: Swim Bike Run Photo (SBRP)
You Sir make 29er wheels look small!
I have a bike next for a cat 6'7" - thanks for some fresh perspective, when you build bikes for guys over 6'4" the #'s start to get daunting, so it's good to see that yes, there are cats who make a 27+" top tube look NORMAL - as many times as you make one, you have to stop & think "Really?" = and that's after having done at least 1/2 dozen bikes for guys OVER 6'5" up to 6'9"
Rock on!
- Garro.
Steve Garro, Coconino Cycles.
Frames & Bicycles built to measure and Custom wheels
Hecho en Flagstaff, Arizona desde 2003
www.coconinocycles.com
www.coconinocycles.blogspot.com
Whatever you did to make the numbers work, you nailed it. I've three bikes, all steel, all handmade, 2 of which were made for my measurements. This is the one that just disappears under me. Its the most stable, easiest to no-hands, most intuitive, yet totally flickable in the tight east coast trails we have out here.
Over a year since receipt and I'm still gushing.
In Garro we trust.
Steve Garro, Coconino Cycles.
Frames & Bicycles built to measure and Custom wheels
Hecho en Flagstaff, Arizona desde 2003
www.coconinocycles.com
www.coconinocycles.blogspot.com
IMG_7759.jpgIMG_7763.JPGIMG_7764.JPGIMG_7774.jpgIMG_7777.JPG
Cruiser #3 of a run of three, then off to Dirt Roadsters
- Garro.
Steve Garro, Coconino Cycles.
Frames & Bicycles built to measure and Custom wheels
Hecho en Flagstaff, Arizona desde 2003
www.coconinocycles.com
www.coconinocycles.blogspot.com
IMG_7814.JPGIMG_7808.JPGIMG_7810.JPGIMG_7811.JPGIMG_7812.JPGIMG_7813.jpgIMG_7809.JPG
These are all steps in my alignment process, this frame with 17.75" effective chain stays and a 26.5" top tube for instance had only a .25mm discrepancy over the whole span of these points, over 111cm from each other, a frame for a guy 6'7".
BB is faced, the seat tube is checked, head tube as well, and the dropouts are in phase to each other, and the axle is centered with the frame, and the dropouts are parallel.
Good to go.
- Garro.
Steve Garro, Coconino Cycles.
Frames & Bicycles built to measure and Custom wheels
Hecho en Flagstaff, Arizona desde 2003
www.coconinocycles.com
www.coconinocycles.blogspot.com
IMG_7889.JPG
MAS y MAS!
- Garro.
Steve Garro, Coconino Cycles.
Frames & Bicycles built to measure and Custom wheels
Hecho en Flagstaff, Arizona desde 2003
www.coconinocycles.com
www.coconinocycles.blogspot.com
No cold-setting
Andrea "Gattonero" Cattolico, head mechanic @Condor Cycles London
"Caron, non ti crucciare:
vuolsi cosě colŕ dove si puote
ciň che si vuole, e piů non dimandare"
Steve Garro, Coconino Cycles.
Frames & Bicycles built to measure and Custom wheels
Hecho en Flagstaff, Arizona desde 2003
www.coconinocycles.com
www.coconinocycles.blogspot.com
Steve Garro, Coconino Cycles.
Frames & Bicycles built to measure and Custom wheels
Hecho en Flagstaff, Arizona desde 2003
www.coconinocycles.com
www.coconinocycles.blogspot.com
Out riding some trail!
- Garro
Steve Garro, Coconino Cycles.
Frames & Bicycles built to measure and Custom wheels
Hecho en Flagstaff, Arizona desde 2003
www.coconinocycles.com
www.coconinocycles.blogspot.com
Blog form of what's up 5/24/15
coconino cycles custom bicycles 928 774 7747 www.coconinocycles.com: Some finished cruiser shots for Tod L
- Garro.
Steve Garro, Coconino Cycles.
Frames & Bicycles built to measure and Custom wheels
Hecho en Flagstaff, Arizona desde 2003
www.coconinocycles.com
www.coconinocycles.blogspot.com
Nice Rohloff setup!
One question, I noticed a trio of braze-on on the curved top tube. What is it for? Thanks.
IMG_8102.jpg
Hey!
On the non-disc side of the fork as well = for the wires from the generator hub to the lights and charger ports.
It has full racks, lights & three H2O bottles as well as hidden fender mounts.
- Garro.
Steve Garro, Coconino Cycles.
Frames & Bicycles built to measure and Custom wheels
Hecho en Flagstaff, Arizona desde 2003
www.coconinocycles.com
www.coconinocycles.blogspot.com
IMG_8152.JPGIMG_8154.JPGIMG_8159.JPG
Best award you can get:
"Got to ride the new orange machine on Monday, it was so much fun. Fit was great and I never felt any pain in my neck during the ride which was the best part. Thanks so much again"
- Garro.
Steve Garro, Coconino Cycles.
Frames & Bicycles built to measure and Custom wheels
Hecho en Flagstaff, Arizona desde 2003
www.coconinocycles.com
www.coconinocycles.blogspot.com
IMG_8213.JPGIMG_8215.jpgIMG_8216.JPG
Not here Friday, the plum crop is ripe so here's an early FNL.
- Garro
Steve Garro, Coconino Cycles.
Frames & Bicycles built to measure and Custom wheels
Hecho en Flagstaff, Arizona desde 2003
www.coconinocycles.com
www.coconinocycles.blogspot.com
Bookmarks