Re: Mills of the Horizontal Persuasion.
Originally Posted by
Paul Jacobs
I know this does not answer your question but I cut my mitres with my lathe. If you have a good lathe this will do the job well. If you don't have a lathe I would get one before a horizontal milling machine because it will do so much else. This is just my opinion.
Semi unrelated, how do those carbide hole saws work out for you? I just bought a similar looking set off Amazon for $25 covering from about 15mm up to 53mm. Have not had a chance to use them yet.
Brian Earle
North Vancouver, BC
Built a few frames in my garage.
Bookmarks