Likes:
0
-
Slip fit tolerance, help, can't visualize
Working on a special project. Need to source 304L from an uncommon source. ID of the 304L is 32mm. XCr is 31.7 OD. My question is about the gap. Can it be filled with Harris 45T?
There is a slightly smaller 304L ID option which is 31.62.
If it were you would you fill the gap with 45T or enlarge the ID of the 31.62?
Adam
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
Bookmarks