I would like to see/hear everyone's technique on bending steel tubing.
I'm sure there are different applications for different pieces.
(i.e. seat stays,chain stays,top tubes,seat tubes)

I haven't tried to bend this thin-wall tube, only heavier stuff on other projects.
(Stuff that isn't prone to dimpling or creasing)
Heat or no heat??
(Dad always said that I would go straight to hell for bending cold metal.)LOL

I've seen some fork jigs,etc.etc. Bending one piece would be a challenge, but to bend an opposite matching pieces would take some planning and skill. yes?

Perhaps there is a thread already...or not.

Thanks in advance...
Luke