https://c1.staticflickr.com/6/5456/3...c4ad7636_h.jpg
Printable View
This is beyond exciting to see my new 27.5+ bike being built. The curves on this frame are off the charts. I can't wait to ride the @#$@ out of it.
For Immediate Release // Vari-Wall THERMLX™ Logo Design.
For more information on the project, head on over to the 44HQ Blog (link above). Really proud to have been part of this project.
https://c1.staticflickr.com/1/481/31...d81ac6bd_c.jpg
Kris,
That orange is HOT!
Hi Kris,
I think you were using an alignment "table" based on a piece of aluminum extrusion a while ago. Is this still the case, or have you moved on to a surface plate? What was your experience with the extrusion based solution? Was it "good enough" in practice for production? Thinking of trying something similar, mainly due to needing to be "mobile".
Thanks,
Alex Vaivars
that's a real BOOM innit? :cool:
Is the front hub Boost?
110mm Front / 148mm Rear
No dropper?