I was thinking about making up a stainless port that terminated the outers of both cables at the headtube and running a pair of thin stainless tubes to an equivlent port in the chainstay - anyone had a go at this before?
Ta
Joe
Printable View
I was thinking about making up a stainless port that terminated the outers of both cables at the headtube and running a pair of thin stainless tubes to an equivlent port in the chainstay - anyone had a go at this before?
Ta
Joe
Joe,
I’ve done a lot of internal Rohloff cable routing, creating both entrance and exit ports.
Here’s one example to peruse...
Groovy Cycleworks 33-988-537: Martins 65b day 2...
Rody
Thanks Rody
My principle concern is the size of the hole in the DT so I was going to go into the top of the headtube too - albeit not with such a neat block. I'll press on.
Many thanks for the link!
No worries Joe, lots more buried in the blog if you care to look.
Best wishes,
Rody