Likes Likes:  0
Results 1 to 2 of 2

Thread: Carbon swingarm/aluminium bearing pivot carrier bonding?

  1. #1
    Join Date
    Apr 2009
    Location
    East Hampton CT
    Posts
    95
    Post Thanks / Like

    Default Carbon swingarm/aluminium bearing pivot carrier bonding?

    Hello all, I made one of my boys a FS bike and re-purposed a Yeti 575 swingarm. The bike works great for him. This past weekend the swingarm became wiggly and we saw that the aluminium pivot-bearing carrier was loose in the swingarm. We dis-assembeled it and the pivot carrier slid out of the end of the swingarm. Neither the swingarm nor the aluminium piece looks to be damaged. We are planning on just re-bonding the two pieces back together and away we go. Interestingly there doesn't look to be too much old epoxy on the aluminium piece.

    I am looking for epoxy and prep recommendations. My plan would be to sandblast the aluminium tab to clean and give some tooth for the glue. Clean the carbon socket with acetone(?). And glue it up.

    This is the bike, we flipped the dopgbone and goofed with the dogbone pivot location to get it to work for him and get some more standover clearance:

    18620475_1119600914851195_657050145527185424_n.jpg

    Thanks for any guidance on this matter. Good day - B
    Bob Spooner
    Departing from
    East Hampton, CT

  2. #2
    Join Date
    Aug 2011
    Location
    Willy, VIC
    Posts
    1,492
    Post Thanks / Like

    Default Re: Carbon swingarm/aluminium bearing pivot carrier bonding?

    Can you post a better pic of the parts to be bonded? There should be an insulating layer, possibly glass fibre, somewhere between the carbon and the aluminium and it is important not to breach that in your prep.

    I have had good success with phosphoric acid anodisation (AKA the Boeing process) when bonding aluminium to carbon.

Similar Threads

  1. Replies: 11
    Last Post: 06-09-2016, 12:20 PM
  2. Seized seat post: steel and carbon bonding.
    By the bottle ride in forum General Discussion
    Replies: 19
    Last Post: 11-07-2015, 01:30 PM
  3. Bonding Carbon Fiber Tubes to Steel Lugs?
    By MagicCycles in forum The Path
    Replies: 8
    Last Post: 07-27-2015, 11:53 PM
  4. Aluminium dropouts for carbon frames
    By Mark Kelly in forum The Path
    Replies: 2
    Last Post: 08-19-2013, 11:36 AM
  5. Replies: 27
    Last Post: 08-12-2013, 12:05 PM

Tags for this Thread

Bookmarks

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •