The Richie-issimo 2.0 Fork Crown atmo -

[e-RICHIE]

Read more here atmo -

Richie-issimo 2.0 Fork Crown | RICHARD SACHS CYCLES

[Loknor]

I'm not sure man, plastic seems so cheap and flexible, but you probably know better than me

Then again... maybe you are going for true Weight Weenyism?

[ron l edmiston]

--- front dimples, RS logo under & side slats/slots all wrapped in a cast --- hoosierism, "*utters just plain utters.." *breast nibbles..

ronnie

[Curt Goodrich]

I'd do it. Especially now that Ronnie uttered breast nibbles.

[shand]

I'm not sure man, plastic seems so cheap and flexible, but you probably know better than me

Then again... maybe you are going for true Weight Weenyism?

I don't mind the plastic but red clashes badly with my skin tone.

[Loknor]

I assume Richie will open source the blueprint, so you can make them in any color possible with this machine:

Ultimaker | the fast, easy to build, affordable 3D printer - 3D printing for everyone!

I do have a question though... which flux and what filler do you need for these?

[devlin]

Do I use brass or silver? I've got some 5% silver solder here somewhere is that good enough?

[Loknor]

I think these parts would go nicely with Richie's new vision!

plastprt.JPG