Cyclocross frameset. 57.3 tt, 56.4 st, 73 st angle

[zank]

SOLD

Hi Folks,
I have an unpainted frameset that needs a home. The order was cancelled mid-build because the original order-placer has a serious back injury and can no longer ride off-road. I would like to offer it up to a Vsaloner. Drop me a PM if you are intereted. Complete specs are below. It has my usual cross bike lugset with plug-in seat stay style seat lug and a straight blade fork. Your choice on paint. Should be ready to ship early October, which is the lead time on paint.

Seat Tube Length (c-c): 56.4 cm
Top Tube Length (c-c): 57.3 cm
Top Tube Slope: 2.0 deg
Head Tube Angle: 72.0 deg
Seat Tube Angle: 73.0 deg
Chainstay Length: 42.5 cm
Head Tube Length: 16.3 cm
Bottom Bracket Drop: 7 cm
Fork Rake: 4.8 cm
Trail: 6.1 cm
Estimated Front Center: 61.5 cm
Estimated Wheelbase: 103.1 cm
Estimated Standover: 83.6 cm
Estimated BB Height: 27.3 cm
Wheel Size: 700c
Tire Size*: 32 mm *Room for up to 35 mm. Trail and BB height based on 32 mm.
Rear Axle Spacing: 130 mm

Top tube cable routing
2 bottle mounts
27.2 mm seat post
1 1/8" seat tube
English BB

Thanks for looking!

[Too Tall]

I'm not biased....much ;) Somebody snap this puppy up and let's see it used hard this season.

You are good man to offer this up here first where you know folks will use it.

[frenk]

Too bad it's a bit too long for me...
CX is a completely unknown sport here, we need to do something and someone has to be the first!

[zank]

Bump on this one. Still looking for a good home. Thanks!

[justinf]

coming clean, I have lurked on this thread frequently. Just a hair too big for me I'm afraid, but I've tried to justify it over and over. Sadly, someone else should grab it.

[brent]

so close...but not quite large enough. darn!!!

[SpeedyChix]

If you run it through a HOT wash and dry.... can you get that TT to 53?

[spamjoshua]

Mostly torso... first post here is to say: "This would fit me well."

A Zank!

Joshua